broadcast

Socket option to permit sending of broadcast messages.

bytes_readable

IO control command to get the amount of data that can be read without blocking.

debug

Socket option to enable socket-level debugging.

do_not_route

Socket option to prevent routing, use local interfaces only.

enable_connection_aborted

Socket option to report aborted connections on accept.

keep_alive

Socket option to send keep-alives.

linger

Socket option to specify whether the socket lingers on close if unsent data is present.

message_flags

Bitmask type for flags that can be passed to send and receive operations.

out_of_band_inline

Socket option for putting received out-of-band data inline.

receive_buffer_size

Socket option for the receive buffer size of a socket.

receive_low_watermark

Socket option for the receive low watermark.

reuse_address

Socket option to allow the socket to be bound to an address that is already in use.

send_buffer_size

Socket option for the send buffer size of a socket.

send_low_watermark

Socket option for the send low watermark.

shutdown_type

Different ways a socket may be shutdown.

wait_type

Wait types.

~socket_base [destructor]

Protected destructor to prevent deletion through this type.

max_connections [static]

(Deprecated: Use max_listen_connections.) The maximum length of the queue of pending incoming connections.

max_listen_connections [static]

The maximum length of the queue of pending incoming connections.

message_do_not_route [static]

Specify that the data should not be subject to routing.

message_end_of_record [static]

Specifies that the data marks the end of a record.

message_out_of_band [static]

Process out-of-band data.

message_peek [static]

Peek at incoming data without removing it from the input queue.